Ironman Fitness Gravity 4000 Owner's Manual page 12

6
Pull out the Large Spring Knob (18), and slide the
Adjustable Boom (3) into the square bracket on
the bottom of the Bed Frame (4) as shown.
Slide the Adjustable Boom (3) upward until the
desired height on the Height Scale (44) is just
below the bracket on the bed frame.
Lock the Adjustable Boom (3) in place by releas-
ing the Large Spring Knob (18) and sliding the
Adjustable Boom (3) up or down slightly until the
Large Spring Knob (18) "pops" down into the
locked position.
For added safety, secured the Knob (30) into the
back side of the bracket on the Bed Frame (4) as
shown.
7
Attach the top end of Handlebar (29) onto the Rear
U-Frame (2) and Pivot Arm Ring (47) with one Hex
Head Bolt (38), Lock Nut (15), and two Washers
(13).
Attach the bottom end of the Handlebar (29) onto
the Rear U-Frame (2) with one Hex Head Bolt (43),
Lock Nut (15), and two Washers (13).
Install the Nut Cap (55) onto the Hex Head Bolt
(38).
Repeat above same steps to attach the other
Handlebar (29) onto the Rear U-Frame (2) and
Pivot Arm Ring (47).
8
Attach the Nylon Strap (32) to the
Strap Lock (34) by inserting the end
of the Nylon Strap (32) up through
the bottom of the Strap Lock (34),
loop the Nylon Strap (32) over the
Pre-assembled Loop Strap (33) and
down through the Strap Lock (34).
Now, loop the strap back over itself,
and insert back through the Strap
Lock (34), and pull tight to secure.
ASSEMBLY
30
29
13
43
19 33 34
12
4
3
13
13
38
55
13
2
19
32 19
18
44
15
47
15
33 34
32
19