Enabling The Dual Display Option - Cisco TelePresence VX Clinical Assistant Installation And User Manual

Installing Options

Enabling the Dual Display Option

The VX Clinical Assistant can accommodate a second
display for an enhanced telepresence session or
presentation. An HDMI EXTENSION CABLE is made
available for easy access to connect to within the
support column.
1. Remove the ACCESS PANEL on the lower column by
unscrewing the THUMBSCREW (1) near the top of the
plate.
2. Locate the HDMI EXTENSION and securely connect the
USER SUPPLIED HDMI CABLE to the EXTENSION.
3. Replace the ACCESS PANEL while ensuring the HDMI
CABLE is able to exit the COLUMN through the egress
at the top of the ACCESS PANEL.
4. Connect the HDMI Cable to the display you intend to
use.
NOTE: Ensure power is provided to the display and is ON.
NOTE: Place the second display on a secure and stable
location to avoid damage or injury.
5. Press and hold (LAYOUT Button) on the SOURCE
CONTROL interface for five seconds to enable the Dual
Display option.
NOTE: When a second display is connected, the default
mode will present Single Display mode where the displays
are mirrored.
6. Use the SOURCE CONTROLS to present different
content on the second display.
NOTE: Turning the system off with the Power Button on
the Battery Meter Panel will revert the Dual Display setting
to Single Display mode. Placing the system on Standby
does not alter the Dual Display setting.
141299.21 Cisco TelePresence VX Clinical Assistant TM CTS-CA2-K9/CTS-CA2-P240V-K9 v1.2 | 2013 JAN | © 2012-2013 Cisco Systems, Inc. All rights reserved.
4
2
3
1
5
19