Installing Optional Wap And Switch - Cisco TelePresence VX Clinical Assistant Installation And User Manual

Installing Options

Installing Optional WAP and Switch

NOTE: Power to the cart should be removed before
installing the WAP or switch.
1. Mount the Power Supply for the Switch into the
base of the system and plug into the provided
Power Bar.
2. Run the Switch's Power Cable up through the
column and plug into the Switch housed inside the
PC Cabinet.
3. Reroute the integrated Network Cable, available
inside the column, up into the rear of the PC
Cabinet and plug into the Switch. Connect the
other end to the WAP.
4. Connect a supplied Network
Cable from the Switch to the
NETWORK port on the rear
of the cart.
NOTE: Clip the Network
Cable to the Strain Relief
Clip at the bottom right
corner of the interface place
with the NETWORK port.
5. Make the appropriate
network configurations per
the requirements of your
organization.
141299.21 Cisco TelePresence VX Clinical Assistant
WAP
Integrated
Network Cable
Strain
Relief Clip
NETWORK
SWITCH
to POWER BAR
inside BASE
POWER for
SWITCH
TM CTS-CA2-K9/CTS-CA2-P240V-K9 v1.2 | 2013 JAN | © 2012-2013 Cisco Systems, Inc. All rights reserved.
18