Installing Optional Wireless Access Point (Wap); Installing Optional Network Switch - Cisco TelePresence VX Clinical Assistant Installation And User Manual

Installing Options

Installing Optional Wireless Access Point (WAP)

If wireless network connectivity is required, mount a
wireless access point (WAP) securely to the cart (see
Wireless Access Point Mount). NOTE: Power to the
cart should be removed before installing the WAP or
switch.
1. If required, install the Power Injector into the base
of the cart, up against the system's Isolation
Transformer, and plug into the provided Power Bar.
2. Use the integrated Network Cable, available inside
the column, to connect the WAP and the "AP"
(Access Point) port on the Power Injector.
3. Connect a supplied Network Cable from the
"Switch" port on the Power Injector to the
NETWORK port on the rear
of the VX Clinical Assistant.
NOTE: Clip the Network
Cable to the Strain Relief
Clip at the bottom right
corner of the interface place
with the NETWORK port.
4. Make the appropriate
network configurations per
the requirements of your
organization.
141299.21 Cisco TelePresence VX Clinical Assistant
WAP
Integrated
Network Cable
Strain
Relief Clip
to POWER BAR
inside BASE
ACCESS
POINT
POWER
SWITCH
INJECTOR
TM CTS-CA2-K9/CTS-CA2-P240V-K9 v1.2 | 2013 JAN | © 2012-2013 Cisco Systems, Inc. All rights reserved.

Installing Optional Network Switch

If additional network ports are requires, mount a network switch into the PC Cabinet
NOTE: Power to the cart should be removed
(see PC Cabinet with Switch).
before installing the WAP or switch.
1. Mount the Power Supply for the Switch into the
base of the cart, up against the system's Isolation
Transformer, and plug into the provided Power Bar.
2. Run the Switch's Power Cable up through the
column and plug into the Switch housed inside the
PC Cabinet.
3. Route a supplied Network Cable from the
NETWORK port on the rear of the cart to the rear
of the PC Cabinet and plug into the Switch.
NOTE: Clip the Network
Cable to the Strain Relief
Clip at the bottom right
corner of the interface place
with the NETWORK port.
4. Connect a Network Cable
from the Switch to an
appropriate network source.
NOTE: If using the optional
Retractable Network Caddy,
connect the loose end of the
cable to the Switch, and connect
the retractable end of the
cable to an appropriate
network source.
5. Make the appropriate
network configurations per
the requirements of your
organization.
Strain
Relief Clip
NETWORK
SWITCH
Optional Retractable
Network Caddy
to POWER BAR
inside BASE
POWER for
SWITCH
17