On entering the set-up utility a main menu screen appears. If there is
an associated sub-menu, or a further sub-menu available, then the
listed options have a preceding bullet, as shown below:
Load default settings
Devices and I/O ports
Date and time
ISA Legacy resources
T E C H N I C A L I N F O R M A T I O N
Information about the system.
Processor, memory, drives etc.
The settings for serial, parallel ports,
IDE interfaces, HDD.
Change the system master clock
View or change access to HDD, user
and administrator passwords.
Boot from A: or C:, keyboard speed,
POST speed etc.
Change the cache settings, ROM
shadowing and other related topics.
Register resources used by new ISA
expansion cards, memory, DMA,
Change settings for the Low power
energy saving mode.
Saves any changes that have been made
Restores all the settings to the values
that were in force when you entered
set-up, same as pressing F9
Restores the settings to their default
(possibly blank) state.
Ends the session and starts the system
POST again. If you have changed any
settings you will be asked if you wish
to save the new settings.