Mitsubishi Electric Apricot VS Owner's Handbook Manual page 42

Removing and fitting a processor
To remove the existing processor:
1. Turn off the computer and unplug all power cords.
2. Take suitable anti-static precautions and remove the system unit
Caution
If you are unfamiliar with the recommended anti-static precautions and/or the
process of removing the system unit cover, refer to Appendix A, "The System Unit".
3. If there are any expansion cards in the way, you may have to
4. To locate the processor ZIFF socket see appendix B, 'System
5. Lift the lever from the locked position until it is upright (at
CKED
cover.
remove them. (Take note of which way all of the cables are
connected.) Disconnect any cables connected to the cards,
remove the screws that secure the cards at the rear of the system
unit, then remove the cards from the system unit.
motherboard'. A lever attached to the socket secures the processor
in the socket.
right-angles to the motherboard). There may be a little stiffness
at the beginning and end of the lever's movement. Be careful not
to use excessive force.
SYSTEM UPGRADES
FREE
4/9