Mitsubishi Electric Apricot VS Owner's Handbook Manual page 32

1. First decide in which of the available slots you wish to install the
card. In general it is easiest to start with the lowest slot and work
upwards.
2. Check on two things, the type of board (ISA or PCI) and then its
length. Not all slots take the same length or type of card.
3. Remove the blanking plate of the chosen slot by removing its
securing screw. On the power supply side, remove the security
plate, then slide the blanking plate out of its slot. Keep all the
screws, etc., they will be needed later to secure the card.
4. If the card you are installing is configured by the means of
jumpers or switches, check that it is correctly configured before
proceeding.
Note
If the card uses the video or audio feature connector on the motherboard, you
may need to connect this before you install the card (otherwise, the card may
get in the way of the connector). See appendix B, 'System Motherboard' for
location of these connections.
8. Position the expansion card alongside the slot in which you wish
to install it. Align the rear of the card with the slot in the rear of
the system unit, and, if the card is full length, align the front of
the card with the card guide.
S Y S T E M E X P A N S I O N
3/7