Sub-Menu Pages - Mitsubishi Electric Apricot VS Owner's Handbook Manual

T E C H N I C A L I N F O R M A T I O N

Sub-menu pages

System summary
This page cannot be edited, but gives a summary of the system main
settings. Changes made in other pages will be reflected here.
Make a note of the information on this page before you progress any
further or make any changes.
Devices and I/O ports
Serial ports 1 & 2 (COM1 & COM2)
Selects the I/O ports and interrupts used by the two serial ports.
Normally set to default settings. Do not disable the serial ports unless
you are absolutely sure you are not going to need them.
Parallel port
This sets the I/O port and interrupt used by the parallel port. You
can select standard, or extended port modes. To obtain the extended
port modes it will be necessary to change the I/O setting.
Standard mode
Extended mode
Any parallel port devices that you may wish to attach, such as a tape
streamer or external hard drive etc., will have full instructions
supplied with them that will tell you if the port capabilities need to
be altered to one of the extended options above.
Mouse
This tells the system that a mouse is connected to the mouse port.
The mouse is then detected by the POST. You should not normally
change this setting.
C/4
Output only.
Bi-directional Simple two way data.
EPP Enhanced parallel port
compatible operation.
ECP Extended capabilities port
operation.