Sleep Mode - Scantech VEGA V-1020 User Manual

Scantech-ID
Set up Server Mode Communication
4.3.3
To set-up the communication between the VEGA scanner and Bluetooth
application device follow the next steps.
1. The VEGA scanner must scan "Scanner Server Mode ON/Scanner
Client Mode Off" barcode, to set the VEGA scanner in server mode.
2. When control the Bluetooth device to search the scanner, enter pin
code (default 00:00:00:00) to setup comport.
3. When VEGA scanner is successful connected, scanner will initiate with
short beep sounds. Blue and red led will also blink followed by a long
beep sound. Blue led will slow flash to finish the set up.

Sleep Mode

4.3.4
The VEGA scanner is equipped with sleep mode function to save battery
energy, when the VEGA scanner is not used for a 1 minute time (option 10
minute). During sleep mode all the functions and connection will be halted,
after press the red trigger button the scanner can be wake up and reconnect
the communication with the cradle or Bluetooth device. By scanning the
according programming code, see chapter 7.
Memory Mode
4.3.5
This memory mode function is enabled when you have scanned "memory on"
barcode. Scanning data is stored in the memory of the VEGA scanner. This
function is disabled when you have scanned "memory off" barcode.
When scan barcode "memory read" barcode stored data will be immediately
transmit to the cradle after reconnection. when scan barcode "memory clear"
barcode all stored memory data will be erased.
The capacity of this memory depends on the scanned data size,
approximately 50 sets of data.