Basic Operation
media data files. You can connect respectively one data storage to
each of the two connectors.
4.6 Installing a Smartcard
If you want to watch scrambled programs, put a Conax smartcard into
the Conditional Access (CA) slot at the receiver's rear panel.
4.7 Connect Power Supply
When all devices are properly connected to the receiver you can con-
nect the mains plug to the power outlet.
4.8 Insert Batteries of Remote Control
This describes the steps for inserting new batteries of the remote
control or for replacing empty batteries:
1. Open the battery compartment on the bottom side of the remote con-
trol. Remove the cover of the battery compartment.
2. Place the two batteries 1.5 V (type: AAA).
Ensure correct polarity!
3. Close the battery compartment
5 Basic Operation
This chapter describes the required steps to be able to use the offer of
radio and TV channels provided via wide-band cable
4
The radio and TV programs available via wide-band cable depend on your respective cable
network provider.
18
For more info about smart card see section
Smartcard
.
Replace the batteries if certain remote control func-
tions are not performed any more or are performed
incorrectly.
When replacing batteries, always ensure that all bat-
teries are replaced.
.
4
3F
smart CX72
CA