Table of Contents
Advertisement
Extended Settings and Functions
7.12
ANT IN / OUT Loop Through (Loop Standby)
Basically, after turning off the receiver it switches to power saving mode
("Deep Standby", red LED lights up). At the ANT OUT terminal there is no
or only a highly attenuated signal. If you want to use ANT OUT anyway,
you can set that in the submenu Other of the System Setup menu:
Select Loop Standby to switch on and off the possibility of looping
through the satellite signal, using the buttons
default is Loop Standby
CAUTION!
7.13 SmartLink (CEC)
If you have a CEC
nected via HDMI you can switch on and off (standby mode) both sets with
the remote control of your smart CX72:
1. Select in the menu System the submenu TV System and press OK.
2. Select SmartLink and use the keys
SmartLink function on and off.
7.14 Software Version
The submenu Information of the menu Tools displays the current version
number of the smart CX72 software.
7.15 Factory Settings
If you erroneously saved wrong settings or if you want to pass on the re-
ceiver without your settings, then you can reset the receiver to the factory
settings (reset):
9
CEC = Consumer Electronics Control = HDMI feature for entertainment units, provides via
HDMI various control functions, e. g. "system standby". The TV set is the control center and
the TV remote control becomes the remote control of the whole system.
54
off
).
If you select Loop Standby
standby mode after switching off, but not into the pow-
er saving mode. The display shows the current time.
-compatible TV set, and receiver an TV set are con-
9
8F
und
On
, the receiver goes into
und
to switch the
(factory
smart CX72
Advertisement
Table of Contents
