Configuring Your Camera; Configuration Using The Wizards - Axis 2420 User Manual

AXIS 2420 User's Manual

Configuring Your Camera

Before you begin:
Successful installation of the product is pre-requisite to configuring the unit. You should therefore read
the following information before commencing with this section:
Installing on a Network, on page 13, or Installing via a Modem, on page 15, and then
•
• Choosing Your Application, on page 32.
Important!
Javascript must be enabled in your browser for the AXIS 2420 Web-based interface to work.
After installing the product, your AXIS 2420 is now attached directly to a local area
network, or connected to a local PC using the supplied Null Modem Cable. You are now
ready to proceed with the configuration of the unit.
This section describes how to use the product Wizards for configuring and integrating the
AXIS 2420 into your application environment, and provides a general overview of the
Web-based Administration Tools.
Note:
On-line help
Web interface. Containing comprehensive details on all product parameters, the on-line help is
your first point of reference when configuring and managing the unit, and particularly useful for
resolving any administration queries.

Configuration Using the Wizards

For speedy development of your application, the AXIS 2420 provides two easy-to-use
Wizards; the Installation Wizard and the Application Wizard, both of which are
recommended for both novice and advanced users alike.
Important!
• When accessing the Administrator Tools for the first time, you will be assumed to be the administrator and
will be logged in as such, with the username root and default password pass.
• You must change the root password as soon as possible. Until this has been done, the security features in
the product be will not be enabled. Furthermore, all Axis products are shipped with the same password by
default. For further information, refer to System Security, on page 24.
• Prior to accessing the Installation Wizard or Administration Tools over a network, you must first set the IP
address, using ARP as described on page 13, or with any alternative method as described in Appendix B -
Other IP Setup Methods.
is stored internally in the AXIS 2420 and is available from most pages in the
Configuring Your Camera
19