Configuring Your Camera; Configuration Using The Wizards - Axis 2110 User Manual

Configuring Your Camera

20
Configuring Your Camera
Important!
Javascript must be enabled in your Web browser for the AXIS 2110 Web-based interface to work.
Before You Begin
Successful installation of the product is prerequisite to configuring the unit; therefore, it is recommended that you
read the following information before commencing with this section:
• Choosing Your Application, on page 26, and then...
• Installing Your Camera on a Network, on page 11...or
• Using Your Camera with a Modem, on page 14
Having chosen the type of application you want to develop and having installed the
product accordingly, your AXIS 2110 will now be attached directly to a local area network,
or connected to a PC using the supplied Null Modem Cable. You are now ready to proceed
with the unit's configuration.
This section describes how to use the Wizards for configuring and integrating the AXIS
2110 into your application environment, and provides a general overview of the
Web-based Administration Tools.

Configuration Using the Wizards

For speedy development of your application, the AXIS 2110 supports two easy-to-use
Wizards that are recommended for both novice and advanced users alike. Depending upon
your choice of application, the Installation Wizard and the Application Wizard can be run
either consecutively, or independently of one another.
Important!
Prior to accessing the Installation Wizard or Administration Tools over a network, you must first set the
IP address, as described in Installing Your Camera on a Network, on page 11.
AXIS 2110 User's Manual