Dial Intercom; To Place A Call On Hold - NEC NEAX7400 ICS M110e User Manual

DIAL INTERCOM

NOTE: Access to feature is based on data assignment.
TO INITIATE
Lift handset or press Speaker key.
Press DICM key.
Dial desired single digit intercom station number (0-9). Tone burst is sent.
(Press 1 to change to ring tone signal).
TO ANSWER
DICM LED lights solid green, indicating an incoming intercom call. Tone
burst or ring tone is heard.
Press DICM.
Lift handset or press Speaker. LCD shows solid green.

TO PLACE A CALL ON HOLD

Press Hold. Held line wink flashes.
NOTE: If held line appears on other D
associated LED flashes red slowly.
TO RETRIEVE
Lift handset or press Speaker.
Press held line. Use handset to converse.
NOTE: Any station with this line appearance can retrieve the call.
IF UNANSWERED
After preprogrammed time, Automatic Recall is initiated.
Visual and audible signal (rapid flash and ring burst) is sent to station that
placed call on hold.
NOTE: Hold shows as a flashing green LED on your phone. The same line on other phones shows as a
flashing red LED. Recall shows as a flashing green LED on your phone and flashing red LED on other
phones with the same line.
term
® stations, the
13
Hold station
number
HOLD 2001
(Time Display)