Wiring The Digital Input / Output - Planet MGSD-10080F User Manual

2.1.6 Wiring the Digital Input / Output

The 6-contact terminal block connector on the front panel of MGSD-10080F is used for Digital Input and Digital Output. Please
follow the steps below to insert wire.
1. The MGSD-10080F offers two DI and DO groups. 1 and 2 are DI groups, 3 and 4 are DO groups and 5 and 6 are GND
(ground).
2. Tighten the wire-clamp screws for preventing the wires from loosening.
3. There are two Digital Input groups for you to monitor two different devices. The following topology shows how to wire DI0
and DI1. We use the MGSD-10080F to be an example for describing DI application.
Figure 2-5 Wiring the Redundant Power Inputs
1 2 3
DI0 DI1 DO0 DO1 GND GND
Figure 2-6 6-Pin Terminal Block DI / DO Wiring Input
41
User's Manual of MGSD-10080F
DI DO GND
4 5 6