Thank you for purchasing PLANET MII family Fast / Gigabit Ethernet module. The MII family Fast / Gigabit Ethernet module can install into PLANET FNSW / FGSW family Switch. The distance can be extended from 100 meters (TP), 2 kilometers (Multi-mode, SC or ST), up to 120...
Chapter 2 MODEL LIST Your MII family Fast / Gigabit Ethernet module comes with one of the following models. Model MII-VSC 100Base-FX Module MII-VST 100Base-FX Module MII-VS15 100Base-FX Module MII-VSA20 100Base-FX Module MII-VSB20 100Base-FX Module MII-GT 10/100/1000Base-T Module MII-SX 1000Base-SX Module MII-LX 1000Base-LX Module MII-L40...
Chapter 3 CHECKLIST Your MII carton should contain the following items: The MII family Fast / Gigabit Ethernet module This user’s manual If any item is missing or damaged, please consult the dealer from whom you purchased your MII family Fast / Gigabit Ethernet module.
● For establishing fiber link with cable length up to 2km (Multi-mode module) and 15/20km (Single-mode module) or 412m (half-duplex mode) ● Slide switch for Half /Full-Duplex selection (default in full-duplex) ● Plug and Play Installation 1. The fiber connector and distance support will be different by various models.
Page 9
Table 1. LED definition of 100Base- FX module Slide switch settings: Figure 2 shows the 100Base-FX module slide switch overview and the screen in Figure 3 appears shows the web settings for working under 100Mbps full-duplex mode and half-duplex mode.
Page 10
Full-duplex mode Software (firmware) 100 Full Table 2. Settings of 100Base-FX module Table 3 below shows the slide switch operation for full duplex and half duplex mode. Slide Switch Description The module works on full duplex mode. The other side must be also configured on full duplex mode.
LED DEFINITION Color Lit: indicate that the port is operating at 1000Mbps. LNK/ACT Off: indicate that the port is operating at 10 Green 1000 Mbps or 100Mbps. Blink: indicate the traffic sending or receiving over that port. Lit: indicate that the port is operating at 100Mbps.
Page 13
Table 5. LED definition of 1000Base-SX/LX Module Function Lit: indicate the link through that port is successfully established. Blink: indicate that the switch is actively sending or receiving data over that port. Lit: indicate that port is operating in full- duplex mode.
4-4 1-Port 1000Base-T/Mini GBIC interface Module- MII-SFP Figure 6. 1-Port 1000Base-T/Mini GBIC Module Front View Features: ● Comply with the IEEE 802.3ab, IEEE 802.3z Gigabit Ethernet stan- dard ● 1-Port 1000Base-T/Mini GBIC interface module ● High performance Store-and-Forward architecture ● Auto-MDI/MDI-X on 1000Base-T port ●...
Page 15
Table 7. LED definition of 1000Base-T port from MII-SFP module Function Lit: indicate the link through that port is successfully established. Blink: indicate that the switch is actively sending or receiving data over that port. Lit: indicate that port is operating in full- duplex mode.
Follow these steps to install the optional module: 1. Power the Switch off before installing the optional module. 2. Place the Switch on a flat surface. Grasp the thumbscrew on the sides of the optional module or blank bracket and turn counter- clockwise to unscrew them.