Operation; I Turning Power On; I General; D Opening Text - Icom iF610 Instruction Manual

2

OPERATION

I Turning power ON

q Push
to turn the power ON.
• A power-up alert tone sounds for about 1 sec. and an
opening message may appear.
w If the transceiver is programmed for a start up passcode,
input the digit codes as directed by your dealer.
• The keys in the table below can be used for password
input.
• The transceiver detects numbers in the same block as
identical. Therefore "01234" and "56789" are the same.
e When the "PASSWORD" indication does not clear after
inputting digit codes, the input code number may be incor-
rect. Turn the power off and start over in this case.
KEY [P
0
NUMBER 0
5
5
] [P ] [P ] [P ]
1 2 3
1 2 3
6 7 8
' ' General
Push to turn the power ON. A power-up alert tone will be
heard. Push
information will sequentially appear on the display.
D D Opening text
The pre-programmed opening text and individual ID will
appear.
The individual ID consisting of a prefix code (3 digits) + a fleet
code (2 digits)+ an individual code (2 or 3 digits) will appear.
(e.g.) If the prefix code is 200, the fleet code 2001, and the
individual code 300, the individual ID will be '2002001300'.
[P ]
4
4 • If you are within the trunking service area, the code (select-
9
ed by [ ]/[
played to indicate that communication is possible.
*In the "-TEXT-" part, the characters pre-programmed by cloning soft-
ware will be displayed.
• If you are outside of the trunking service area, or if the sys-
tem is down,
At this time, the transceiver is searching for any available
system-controlled channel.
again to turn the power OFF. The following
(OPENING TEXT)
201 2001 300
]) and the received signal strength, are dis-
-TEXT-
will blink.