D Mounting The Transceiver; I Optional Ut-109/Ut-110 Installation - Icom iF610 Instruction Manual

D Mounting the transceiver

The universal mounting bracket supplied with your transceiv-
er allows overhead mounting.
• Mount the transceiver securely with the 4 supplied screws
to a thick surface which can support more than 1.5 kg.
Flat
washer
Spring
washer
When using self-
tapping screws
CONNECTION AND MAINTENANCE
I Optional UT-109 /UT-110
installation
q Turn power OFF, then disconnect the DC power cable.
w Unscrew the 4 screws, then remove the bottom cover.
e Cut the print pattern on the PCB at the TX mic circuit (A)
and RX AF circuit (B) as shown in the following figure.
r Install the scrambler unit as shown in the following left.
t Return the bottom cover and screws to the original posi-
tion.
• Install the unit • Cut the print pattern
NOTE: Be sure to re-solder the above dis-
connected points, otherwise no TX modula-
tion or AF output is available when you
remove the scrambler units.
8
Front panel
A
B
26