Operation; Turning Power On; Channel Selection - Icom IC-F1020 Instruction Manual

OPERATION
.Turning power ON
• Channel selection
KEY
~ ~
8 EJ [7]
NUMBER
0
1 2 3 4
5 6 7 8
9
~Bank
number
e
-, J-flM -
_ I
rlJ_--
LLUJI
@ Push [CH UP] or [CH ON] to select
the desired channel in the selected bank.
BANK-TYPE:
CD
Push [BK 5], then push [CH UP] or [CH ON] to select the de-
sired bank number; or
Push [BK UP] or [BK ON] if the
transceiver has these keys.
NON-BANK TYPE:
Push the [CH UP] or [CH ON] keys to select the desired oper-
ating channel, in sequence; or,
push one of the [CH 1] to [CH 4] keys to select these channels
directly.
There are several types are available, and channel selection
method may differ according to your system:
Inc
TI-flM
LLUII
OC 1"1,)',flOIl
J
I __
/I~
U
J •
JJ
Input your password if
this display appears.
Opening message may
differ depending on the
pre-setting.
CD
Push
[CD]
to turn the power ON.
• A power-up alert tone sounds for
about 1 sec. and an opening mes-
sage may appears.
@
If the transceiver is programmed
for start up passcode, input digit
codes as directed by your sys-
tem operator.
• The following keys can be used for
the password input:
The transceiver detects the numbers in the same block as the
same number. Therefore the same effect for "1234" and "6789."
®
When the "PASSWORD" indication does not clear after 4-
digit input, the input code number may be incorrect. Turn
power off and start over in this case.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or taking the micro-
phone off from the microphone hanger.
6