Precaution - Icom iF610 Instruction Manual

PRECAUTION

WARNING! NEVER
AC outlet. This may pose a fire hazard or result in an electric
shock.
NEVER
connect the transceiver to a power source of
more than 16 V DC such as a 24 V battery. This connection
will ruin the transceiver.
NEVER
cut the DC power cable between the DC plug
and fuse holder. If an incorrect connection is made after cut-
ting, the transceiver might be damaged.
NEVER
place the transceiver where normal operation
of the vehicle may be hindered or where it could cause bodi-
ly injury.
NEVER
allow children to touch the transceiver.
NEVER
expose the transceiver to rain, snow or any liq-
uids.
USE
supplied microphone only. Other microphones have
different pin assignments and may damage the transceiver.
ii
connect the transceiver to an
DO NOT
use or place the transceiver in areas with tem-
peratures below –22°F (–30°C) or above +140°F (+60°C) or,
in areas subject to direct sunlight, such as the dashboard.
AVOID
operating the transceiver without running the vehi-
cle's engine. The vehicle's battery will quickly run out if the
transceiver is in transmission while the vehicle's engine OFF.
AVOID
placing the transceiver in excessively dusty envi-
ronments.
AVOID
placing the transceiver against walls. This will
obstruct heat dissipation.
AVOID
the use of chemical agents such as benzine or
alcohol when cleaning, as they damage the transceiver sur-
faces.
BE CAREFUL!
The transceiver will become hot when
operating continuously for long periods.
For U.S.A. only
CAUTION: Changes or modifications to this transceiver, not
expressly approved by Icom Inc., could void your authority to
operate this transceiver under FCC regulations.