Tool Operation - Ozito OZPBS280WA Operation Manual

TOOL OPERATION

BE SURE TO DISCONNECT THE BELT SANDER FROM THE POWER SUPPLY
BEFORE INSTALLING OR REMOVING THE SANDING BELTS
Removing and Installing Sanding Belts
TO REMOVE BELT:
1. Place the palm belt sander on its left side with the belt release lever (7) facing
upwards. Lift up and push the belt release lever (7) towards the front of the
sander until the front pulley retracts and locks into the belt tension release mode.
2. With the palm belt sander on its left side, you can easily remove the belt by
easing both sides up simultaneously.
TO INSTALL BELT:
1. While the palm belt sander is on its left side and the front pulley retracted and
locked, insert the new belt around both pulleys and over the platen plate.
Ensure the sanding belt is placed up to but not over the lip on the front pulley.
If the belt has rotation direction markings, make sure the arrow on the inside of
the belt is pointing in the direction of rotation as indicated on the housing.
Failure to do so will cause the belt to break.
2. Once the belt is in place, return the belt tension release (7) lever back to its
original position to tension the belt.
Switch
Your palm belt sander is supplied with the On/Off switch (1). "0" indicates off. "1"
indicates on.
The On/Off switch (1) is located on the front of the palm belt sander and allows
continuous operation at a maximum of 380m/min.
TO SWITCH ON: Press the On/Off switch (1) to the "1" position. Ensure motor
reaches maximum speed before applying the tool to the working surface.
TO SWITCH OFF: Press the On/Off switch (1) to the "0" position. Ensure the sanding
belt stops turning before placing the tool onto work surface or bench top.
Warning! Prior to connecting the tool to the power supply, ensure the
! !
switch is not turned on.
Tracking Adjustment
Turn the palm belt sander upside down and hold
it firmly with one hand. (Fig.1) Start motor and
observe the tracking of sanding belt. If the belt
runs outward, turn tracking adjustment knob (5)
clockwise, if belt runs inward turn tracking knob
(5) counter clockwise.
Adjust the belt until the outer edge of the belt is
even with the outer edge of both front and rear
pulleys. Make sure the belt does not rub against
the rear guide strip.
8
Fig. 1
3