Table of Contents
Advertisement
GENERAL (cont.)
16. Check for damaged parts. Before use carefully check the tool and power lead
for damage. Check for misalignment and seizure of moving parts, breakage of
parts, damage to guards and switches and any other conditions that may affect
its operation. Ensure that the tool will operate properly and perform its intended
function. Do not use the tool if any parts are damaged or defective. Do not use
the tool if the switch does not turn it on and off. Have any damaged or defective
parts repaired or replaced by an electrician or a power tool repairer. Never
attempt any repairs yourself.
17. Unplug the tool. Shut off the power and wait for the tool to come to a
complete standstill before leaving it unattended. Unplug the tool when it is not
in use, before changing any parts of the tool, accessories or attachments and
before servicing.
18. Avoid unintentional starting. Do not carry the tool with a finger on the on/off
switch. Be sure the tool is switched off when plugged in.
19. Do not abuse the cord. Never carry the tool by its cord or pull it to disconnect
from the socket. Keep the cord away from heat, oil and sharp edges.
20. Store idle tools. When not in use, tools should be stored in a dry, locked up
or high place, out of reach of children.
21. Maintain tools with care. Keep tools clean and in good condition for better
and safer performance. Follow the instructions for maintenance and changing
accessories. Keep handles and switches dry, clean and free from oil and grease.
22. For equipment with type Y attachment, if the supply cord is damaged, it shall
be replaced by the manufacturer or its service agent or similarly qualified
person in order to avoid a hazard.
23. Repairs. This tool complies with relevant safety requirements. Repairs should
only be carried out by qualified persons using original spare parts; otherwise
this may result in considerable danger to the user.
TOOL OPERATION
Auxiliary Handles
Two auxiliary handles are supplied with your tool; one can be installed in three
positions by removing the rubber grommet and screwing the handle into the gear
case housing.
The other (Loop Handle) can be installed by attaching the handle with the bolts
supplied. Either of these handles should be used at all times to maintain complete
control of the tool.
6
Advertisement
Table of Contents
