Advertisement
OPERATION
4. CONTROLS
WARNING!
THE POWER SUPPLY FOR THIS PRODUCT
SHOULD BE PROTECTED BY A RESIDUAL CURRENT
DEVICE (RATED AT 30mA OR LESS).
On/Off Switch
1 To start the sander, press the
on/off switch forward into the
on position ("I").
I
0
Variable Speed Dial
1 To operate the sander at
a slower speed, rotate the
variable speed dial to a lower
number.
2 To operate the sander at
a faster speed, rotate the
variable speed dial to a
higher number.
2 To stop operation, press the
on/off switch backward into
the off position ("0")
I
0
1
2
4
5
5. SANDING
1 If required, secure the
material to be sanded so that
it doesn't slip from under the
sander.
2 Firmly grip the sander
and press the on/
off switch into the on
position.
3 Lower the sander onto the work piece and use a back and forth
motion.
Note:
Do not apply pressure on the sander. Allow the sander to do the
work.
CAUTION:
GUIDE THE CORD DURING SANDING TO
PREVENT IT BEING CAUGHT ON THE WORK PIECE OR
OTHER OBJECTS.
•
Check your work piece often. The sander is capable of removing
material rapidly, especially with coarse paper.
•
Do not sand on one spot for too long. The sander's rapid action
may remove too much material, creating an uneven surface.
I
0
FSR-3000
Advertisement
