Table of Contents
Advertisement
U
sing and
Using and replacing the surface light
(Freestanding model)
The surface light is in the backguard. It is
controlled by the Surface Light Command
Pads on the control panel. The ON
Command Pad turns on the light immediately
and keeps it on until you press OFF. The
Night Command Pad will turn on the surface
light automatically when the light in the room
is low enough to require a night light. When
the night light comes on, it will also dim all
lights appearing on the display. Press OFF
to turn off the regular surface light or press
NIGHT again to turn off the night light.
To turn on the surface light:
PRESS
SURFACE LIGHT
ON
To turn off surface light:
PRESS
SURFACE LIGHT
To turn on night light:
PRESS
SURFACE LIGHT
NIGHT
"NIGHT LIGHT" shows on the display when
the night light is on.
To turn off night light:
PRESS again
SURFACE LIGHT
NIGHT
16
C
Y
aring for
OFF
C
our
ooktop
Replacing the surface light:
1.
Unplug range or disconnect power.
2.
Flip up the top of the backguard.
3.
Pull up glass on front of backguard.
4.
Grasp the fluorescent light tube at both
ends. Turn the tube approximately 90°
in either direction until both ends come
out of the receptacles. Replace with a
20-watt cool-white fluorescent light tube.
Advertisement
Table of Contents
