Table of Contents
Advertisement
Battery Charger
This light and compact charger (DYN4113) quickly and
easily charges 5–8 cell Ni-MH battery packs with an
installed EC3
™
power connector.
Instructions
1. Connect the AC power cord to the power slot on
the charger, then connect the other end of the
power cord to an AC power source.
2. The Power LED and Charging LED will turn
GREEN when the charger is connected to
the AC power source.
Antenna Tube Installation
1. Carefully feed the end of the receiver antenna
through the grommet inside the hull.
2. Pull the antenna wire out of the grommet
towards the outside of the boat, then slide the
antenna through the antenna tube.
Decal Application
3
1
2
Ensure the boat hull is clean. Lift a decal from
the sheet and carefully apply it to the boat
hull for the color scheme you desire.
Transmitter Battery Installation
Impulse 17 • Miss GEICO 17
8
4 5
6
7
1
3. Connect the battery pack connector to the
charge connector.
4. Press the On/Off button to charge the battery.
The Charging LED turns RED.
5. When the battery pack is fully charged, the Charging
LED will turn GREEN.
6. Press the On/Off button to stop charging. Disconnect
the battery pack connector from the charge connector.
CAuTION: If at any time during the charge
process the battery pack(s) becomes hot to
the touch, unplug the battery immediately
and discontinue the charge process.
3. Insert the tube into the grommet, then fit the cap
onto the tube.
4. Apply clear tape to the antenna, grommet and hull
of the boat to keep the antenna from moving.
The outer end of the antenna must be installed above
the waterline of the boat to get the best reception
of your transmitter's signal.
5
(opposite 4)
3
(opposite 2)
This transmitter requires 4 AA batteries.
1. Remove the battery cover from
the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
8
(opposite 7)
4
6
2
7
5
Advertisement
Table of Contents
