Feature Programming; To Enter Feature Programming; Routine - Directed Electronics AM1 Installation Manual

feature programming

The feature programming routine is used to access and change any of the feature set-
tings in the two menus below. The feature settings can be accessed and changed by
using one of the following:
The integrated LED/Valet
Use of the Directed Electronics Bitwriter
ming options are only available when using the Directed Electronics Bitwriter
N N O O T T E E : : If Feature Programming Lockout is set to ON, all features will be locked and
can O O N N L L Y Y be accessed by using a Bitwriter
to enter feature programming routine
1. Open a door.
2. Turn the ignition on and then off.
3. Close the door.
4. Within 5-seconds, press and HOLD the integrated LED/Valet
onds the horn will sound once to indicate entry into the first features menu. To select
the second features menu, continue to hold the integrated LED/Valet
horn sounds twice. Once the desired menu is selected, release the integrated
LED/Valet switch.
®
5. Within 5-seconds, press and release the integrated LED/Valet
of times corresponding to the desired feature listed below. Then press the integrated
LED/Valet switch one more time and h h o o l l d d . The horn will sound the number of times
®
equal to the feature number selected.
6. While holding the integrated LED/Valet
tory button by either pressing Lock for 1 short horn honk setting or pressing Unlock
for 2 short horn honk setting.
26
® switch to enter the feature programming routine.
is recommended. Expanded program-
®
® .
switch, assign the selected feature to a fac-
®
.
®
switch. After 3-sec-
®
switch until the
®
switch the number
®
© 2005 directed electronics, inc.