Table of Contents
Advertisement
Function Table
Valet button presses
(Chirps/Flashes)
1
2
3
4
5
6
7
8
*Press any remote button to program the standard button configuration as
described in the owners manual.
** Press any button of a programmed remote to delete all remote controls from
the system and to reset the features to default settings.
System Feature Programming
The system features are pre-programmed to default settings and may need to
be changed to accommodate vehicle specific requirements and user prefer-
ences. To change the system feature settings use the following procedure:
Important: Test the systems Ignition input, Door trigger input, Valet button,
Status LED, and siren for proper operation before proceeding.
1.
Select a System Feature and required number of Valet button presses as
described in the following Features table.
2.
Open a door, turn the key ON, and then OFF.
3.
Press and release the Valet button to select the feature. After pressing
and releasing corresponding to the selected function, then press the Valet
button once more and hold it. The LED flashes and the siren sounds to
confirm the selection.
4.
While still holding the Valet button press the
© 2011 Directed Electronics. All rights reserved.
System Function
Arm/Disarm/Panic
Aux Channel 2
Aux Channel 3
Arm only
Disarm only
Panic only
Auto-learn standard configuration*
Delete remote controls & Reset features**
button on the
9
AUX
AUX
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 3100 and is the answer not in the manual?
Questions and answers
install avital 1300 on dodge Durango 2001 Door lock single wire
To install the Directed Electronics Avital 1300 on a 2001 Dodge Durango using a single wire for door lock:
1. Use the Door Lock 3-Pin Connector (H2).
2. Connect the GREEN wire from H2 pin 1 to the vehicle’s lock/unlock wire. The GREEN wire provides (-) lock and (+) unlock output.
3. Confirm if the vehicle's lock system matches the system’s output type. If not, a 451M Door Lock Relay Satellite or two relays may be needed.
4. Ensure all other wiring (power, ignition, ground, siren output) is connected properly according to the main harness (H1) pinout.
Important: Professional installation is recommended.
This answer is automatically generated