To Exit The Learn Routine; On-Board Dual Stage Shock Sensor - Directed Electronics AM1 Installation Manual

N N O O T T E E : : If the Unlock learn was unsuccessful, the Unlock procedure can be repeated
by using the LOCK learn procedure, except that at step 4 press and release the inte-
grated LED/Valet® switch TWICE. (The LED will flash in groups of two flashes.)

to exit the learn routine:

Do one of the following:
Turn the ignition on.
No activity for longer than 15 seconds.
Press the integrated LED/Valet

on-board dual stage shock sensor

Less Sensitive
There is a dual-stage shock sensor inside the control module. Adjustments are made via
the rotary control as indicated above. Since the shock sensor does not work well when
mounted firmly to metal, we recommend against screwing down the control module. The
full trigger of the onboard shock sensor reports zone 2. See Table of Zones.
N N O O T T E E : : When adjusting the sensor, it must be in the same mounting location that it will
be after the install is completed. Adjusting the sensor and then relocating the module
requires readjustment.
© 2005 directed electronics, inc.
switch too many times.
®
More Sensitive
23