Advertisement
$XGLR%RDUG
)LJXUH$XGLR%RDUG5HPRYDO
1. Remove the back cover assembly.
2. Remove the keyboard assembly.
3. Remove the palmrest assembly.
4. Remove the 5-mm screw securing the audio shield.
5. Remove the 5-mm screw securing the EMI drain wire.
6. Remove the audio shield.
7 . Disconnect the speaker wires and microphone wire from their connectors
on the audio board.
The connectors are fragile—do not pull on the wires to disconnect them.
8. Remove the audio board from the bottom case.
NOTE: When you replace the audio shield, ensure that the audio shield is
properly seated to prevent it from cutting into the speaker wires or interfering
with devices installed in the modular bay. (You can check this by temporarily
installing a device in the modular bay prior to reinstalling the palmrest
assembly.)
microphone
connector
speaker
connectors
speaker wires
Dell Latitude CPiA Service Manual
5-mm screw
audio shield
audio board
31
Advertisement
