Advertisement
3DOPUHVW$VVHPEO\
The palmrest assembly consists of the touch pad and the palmrest.
palmrest assembly
5-mm screws (2)
bottom
case assembly
)LJXUH3DOPUHVW$VVHPEO\5HPRYDO
1. Remove the keyboard.
2. Disconnect the touch-pad cable from ZIF connector JP2 on the system
board.
3. Remove the back cover assembly.
4. Remove the following screws securing the palmrest to the computer:
‡
One 5-mm screw inside the computer, adjacent to the thermal cooling
assembly.
‡
Two 5-mm screws inside the upper edge of the hard-disk drive bay.
(You must remove the hard-disk drive to access these screws.)
‡
Three 12-mm screws underneath the front edge of the computer.
12-mm screws (3)
Dell Latitude CPiA Service Manual
5-mm screw
19
Advertisement
