Direct Operation; Starting The Fireplace For The First Time - Travis Industries 564 HO Owner's Manual

Direct Operation

The fireplace may be directly operated from the battery holder. The three positions are below (see
ON – Burner turns on (regardless of transmitter settings).
OFF – Burner turns off (regardless of transmitter settings).
REMOTE – Burner is controlled by the transmitter.
NOTE: When the battery holder switch is turned to ON or OFF, the mode settings (Flame Height, Comfort
Control) will remain in the same state as before the switch was moved (i.e.: the IFC "remembers" the last
setting). If you wish to adjust the mode settings use the transmitter mode button to adjust the settings
(see "Mode Controls" on page 13). The thermostat and burner on/off operating functions will not work on
the transmitter.

Starting the Fireplace for the First Time


Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will
cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This
is normal. We recommend opening a window to vent the room.

Condensation may appear on the glass each time you start the fireplace - this is normal.

Blue Flames will occur on the fireplace when it first comes on. After fifteen minutes the flames will
turn a more realistic yellow and orange color.

Certain installations use a remote, thermostat, or wall switch to turn the fireplace on and off. If this is
the case, leave the ON/OFF switch "ON".

Verify the power backup batteries are installed (see page 15).
© Travis Industries
Operation
4140221
9
):
Figure 3
Figure 3
100-01293