Fingerprint Reader Board - HP dv3 Entertainment PC Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board (includes fingerprint reader board cable)
Before removing the fingerprint reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard and switch cover (see
d. Display assembly (see
e. Top cover (see
Remove the fingerprint reader board:
1. Turn the top cover upside down, with the front toward you.
2. Remove the two Phillips PM2.0×2.0 screws (1) that secure the fingerprint reader board to the top
cover.
3. Remove the fingerprint reader board (2) from the top cover.
Reverse the above procedure to install the fingerprint reader board.
Battery on page 32).
Hard drive on page 38)
Optical drive on page
Keyboard and switch cover on page
Display assembly on page
Top cover on page 49)
35)
43)
Component replacement procedures
Spare part number
506962-001
40)
51