Disconnect The Three Electrical Connectors By; Operating Procedures; Pulling Them Straight Out From The Receptacles; Do Not Twist The Connectors, Twisting Will Dam - Hiniker V-PLOW 1851 Operator's Manual

Retract Cylinder With Upper Lift Links
Swing the latch handle open until the latch
sliders are fully removed from the attachment
prongs.
Swing Handle To Remove Sliders
Lower the parking stand to the ground by remov-
ing the tab lock pin from the stand index plate,
then swinging the stand to the ground with the
lever. Reinstall the pin in the index plate through
the hole closest to the front of the lever to hold
the stand in place.
Lower and Pin Parking Stand

Disconnect the three electrical connectors by

pulling them straight out from the receptacles.

Do not twist the connectors, twisting will dam-

age the connector pins or the wiring harness.

DWG NO. 4167
Disconnect Plugs
Back inside the truck, return control of the head-
lights to the truck and switch power off on the
joystick control box, then slowly back the truck
out from the plow.
DWG NO. 3856
Turn Off Lights and Power
If the snowplow won't be used for an extended
period of time, the prong weldment can be re-
moved from the truck by removing the hex bolts
that fasten it to the truck mount frame.
DWG NO. 4168

Operating Procedures 7

DWG NO. 5233
DWG NO. 4164