Hiniker V-PLOW 1851 Operator's Manual page 23

22. Check that the plow blade is level on the
ground with the wings in the scoop position
and the plow on the ground.
Level the plow by first loosening the jam
nut on the stop bolt at the back of the
center mast, then turning the bolt in or
out to adjust the plow ends. Retighten
the jam nut once the plow is level with
the ground. Grease the fitting to prevent
future corrosion.
23. Fasten the power unit cover assembly onto the
lift frame bracket with two 1/4 inch X 3/4 inch
carriage bolts, flat washers and lock nuts
from the hardware bag in the parts box.
Tighten the lock nuts so that the assembly
is secure, yet the cover hinges freely.
Snip the plastic tie strap inside the cover as-
sembly to release the two cover latch han-
dles. When the cover is closed, rods from
the latch handles should extend behind the
light brackets to hold the cover in place.
24. Assemble side markers on the ends of the
DWG NO. 3847
DWG NO. 4198A
moldboard with 5/16 inch bolts, flat washers
and lock nuts.
V-Plow Assembly 21