Hiniker V-PLOW 1851 Operator's Manual page 19

Refer to drawing 3908. Remove the tape
from the Black corrugated loom at the
points shown. Locate an Orange, Red, and
two Black wires. These wires connect to the
battery and pump solenoid. Remove the
four wires from approximately 33 inches of
the loom, making sure the Red and Black
wires are long enough to connect to the bat-
tery. Tuck these wires back into the loom as
shown in the drawing and retape the loom.
10. If there is no access hole in the drivers side
firewall then drill a 1-1/8 inch diameter hole.
Route the 7-pin and 3-pin circular connec-
tors through the firewall into the cab com-
partment and install the 4 inch grommet in
the hole, if required.
CAUTION: Ensure that the relays will
clear any hood lift/spring mechanisms
before installation.
11. Select an area near the drivers side fender
for the relays. Drill three 1/8 inch diameter
holes and secure the relays with #8 X 1/2
inch self-tapping screws from the hardware
bag in the parts box.
12. Splice the red with white stripe wire to the
vehicle's switched 12 volt auxiliary electri-
cal circuit. This will prevent operation of the
plow without the vehicle key being on. This
wire controls the accessory relay that pow-
ers the control joystick and solenoids.
13. Connect the joystick control box to the 7-pin
and 3-pin connectors inside the truck cab.
Secure the box at a safe location in the cab
with the strip of hook and loop fastener.
V-Plow Assembly 17
DWG NO. 3908