Hiniker V-PLOW 1851 Operator's Manual page 16

14 V-Plow Assembly
Mount the power unit on the lift frame with
two 3/8 inch X 3/4 inch hex bolts and two
3/8 inch lock washers. The plastic reservoir
of the power unit should be to the left side
of the plow (see following illustration).
Locate five O-ring/flare hydraulic adapters
in the hardware bag: four straight adapters
and one 90 adapter. Turn the O-ring ends
O
of two straight adapters into ports marked
"W1" and "W2" on the power unit. Turn the
O-ring end of the remaining two straight
adapters into ports in the wing cylinders.
Turn the O-ring end of the 90
the port marked "L" on the power unit, with
the flared end directed toward the fitting on
the lift cylinder.
Assemble the short hydraulic hose from the
parts box between the lift cylinder and the
power unit port marked "L". Route the hose
ahead of the lift frame tube.
DWG NO. 4190A
adapter into
O
6.
DWG NO. 4191A
Route the two longer hydraulic hoses
through the loop on the push frame and
over the two RH trip springs such that the
straight hose ends will assemble to the wing
cylinders on the plow blade and the 90
will assemble to the power unit.
Connect the RH wing cylinder to port "W1"
on the power unit.
Connect the LH wing cylinder to port "W2"
on the power unit.
Band the two wing hoses to the inner slot
in the spring bar at the approximate dimen-
sions shown in the drawing. Also band the
hoses together just ahead of the hose loop
and again about half way between the pre-
vious two straps. Pull slack hose behind the
hose loop.
Before assembling the headlamp brack-
ets on the lift frame tube, scrape a small
amount of paint from the three holes in each
bracket and the four holes in the frame tube
to provide a good electrical ground for the
turn signals and parking lights.
Mount the headlamp brackets to the lift
frame tube with four 3/8 inch X 2 inch car-
riage bolts and flanged lock nuts from the
hardware bag in the parts box.
Remove the LH and RH headlamps from
their boxes and mount on the brackets with
hardware from the headlamp boxes.
Use plastic tie straps to band headlamp
cables above and below the brackets at the
locations shown to provide clearance for
the power unit cover rods later.
DWG NO. 4197A
ends
O