Table of Contents
Advertisement
16 V-Plow Assembly
WARNING: Disconnect truck battery
before beginning electrical installa-
tion to avoid shock hazard.
The pump solenoid, underhood wiring harness,
power cable and joystick control box are locat-
ed in the parts box shipped with the snowplow
frame.
NOTE: Fill electrical connectors with dielectric
grease, and lightly coat ring and spade termi-
nals before installation to prevent corrosion.
8.
Refer to drawing 3907. To begin underhood
wiring installation, lay the harness in it's ap-
proximate position for final assembly. Posi-
tion the 7-pin and 3-pin circular connectors
near the drivers side firewall, the 10-pin and
3-pin connectors just left of center near the
grill, the relays near the drivers side inner
fender and the 5-pin headlight connectors
at the respective headlights.
9.
Determine the location of the vehicle bat-
tery. If the battery is located on the right
(passenger) side or if there are two batter-
ies configured as a 12 volt system then pro-
ceed to step 10. If the battery is located on
the left side of the vehicle then the wiring
harness will need to be modified.
DWG NO. 3907
Hide quick links:
Advertisement
Table of Contents
