Table of Contents
Advertisement
Installing the Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter 2-3
6. Locate the PCI bus expansion slots. Refer to the documentation that
came with your server for the specific location of these slots.
7. Depending on your server model, remove the retaining screw or open
the expansion slot latches that secure the PCI slots.
8. Remove the slot cover from the PCI slot. (You may want to save this
protective cover to use if the slot becomes empty again.)
9. Install the adapter into the PCI slot and press it firmly into place. The
contacts on the adapter edge should be fully seated in the system board
connector.
10. Depending on your server model, secure the adapter by replacing the
retaining screw or by closing the slot latch.
To connect the adapter to other devices, proceed to the next section, "Cabling
the 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter."
Cabling the 64-Bit/66 MHz Single Channel
Wide Ultra3 SCSI Adapter
The 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter can be
connected to external SCSI devices (located in outside units) or to internal
SCSI devices (located in the server). The following sections provide cabling
information for both external and internal connections.
IMPORTANT: All SCSI devices (except CD-ROM drives) that are on the same SCSI bus
must be either internal to the server or in an external storage system, but not both. When
using both internal and external SCSI devices, connect each type to a separate port.
External SCSI Connections
To connect the 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter to
SCSI devices located outside the server, you will need one external SCSI cable
for each channel to which you are connecting.
Advertisement
Table of Contents
