Windows 2000 - Compaq 154060-002 Installation Manual

Windows 2000

Use the following instructions to install the driver on a system already running
Windows 2000. The driver file, named ADPU160M.SYS, is located on the
Compaq SmartStart and Support Software CD supplied with your new
64-Bit/66-MHz Single Channel Wide Ultra3 SCSI Adapter.
1. Start Windows 2000 on the system and log on to an account with
administrative privileges.
2. Insert the Compaq SmartStart and Support Software CD into the CD
drive.
3. Click Start, choose Settings, and click Control Panel.
4. Double-click the System icon.
5. Click the Hardware tab.
6. Click Device Manager to display a list of all the hardware devices
installed, then scroll down to SCSI and RAID Controllers and open the
folder.
You should see the SCSI Controller listed if the SCSI adapter was
properly installed as described in Chapter 2.
7. Double-click the SCSI Controller.
8. Click the Driver tab on the SCSI Controller Properties screen, then click
the Update Driver button.
9. Click Next.
10. Select Display A List Of The Known Drivers For This Device So That I
Can Choose A Specific Driver, then click Next.
11. Click Have Disk and change the drive letter to point to your CD drive.
12. Select the driver file ADPU160M.SYS found in the following directory
root:
\CPQSUPSW\NTSSD\SCSI\160M\ADPU160M.SYS
13. Click OK to add the driver to be installed.
14. Click Next.
You may see an Update Driver Warning screen; click Yes to proceed.
15. The driver you have copied will be listed. Select it and click Next to
install.
16. Click Finish to exit this setup.
Installing the Firmware and Software 3-5