Installing The Drivers; Windows Nt 3.51 Or 4.0 - Compaq 154060-002 Installation Manual

3-4 Compaq 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI Adapter Installation Guide

Installing the Drivers

Windows NT 3.51 or 4.0

If you have not yet installed your new 64-Bit/66 MHz Single Channel Wide
Ultra3 SCSI Adapter, you can do so at this time. See Chapter 2 for general
hardware installation and cabling information, then proceed to the next
section, "Installing the Drivers."
Software drivers must be installed in the server to enable communication
between the processor and the new 64-Bit/66 MHz Single Channel Wide
Ultra3 SCSI Adapter. This installation procedure assumes that you have
already installed your 64-Bit/66-MHz Single Channel Wide Ultra3 SCSI
Adapter and your operating system. The drivers and installation procedures are
unique to the operating system being used. Use the information in this section
to find the location of the driver (or drivers) and necessary installation
information for your operating system. All the drivers and support
documentation can be found on the Compaq SmartStart and Support Software
CD supplied with your new 64-Bit/66 MHz Single Channel Wide Ultra3 SCSI
Adapter.
Use the following instructions to install the driver on a system already running
Windows NT 3.51 or 4.0. The driver file, named ADPU160M.SYS, is located
on the Compaq SmartStart and Support Software CD supplied with your new
64-Bit/66-MHz Single Channel Wide Ultra3 SCSI Adapter.
1. Start Windows NT 3.51 or 4.0 on the system and log on to an account
with administrative privileges.
2. Insert the Compaq SmartStart and Support Software CD into the CD
drive.
3. Click Start, choose Settings, and click Control Panel.
4. Double-click the SCSI Adapters icon.
5. Choose the Drivers tab and click Add.
6. Click Have Disk and change the drive letter to point to your CD drive.
7. Select the driver file ADPU160M.SYS found in the following directory
root:
\CPQSUPSW\NTSSD\SCSI\160M\ADPU160M.SYS
8. Click OK to add the driver to be installed.
9. Click OK again to copy the driver into your system and exit this setup.