Computer Setup (F10) Utility; Computer Setup (F10) Utilities; Using Computer Setup (F10) Utilities - HP TouchSmart 9100 Maintenance And Service Manual

5

Computer Setup (F10) Utility

Computer Setup (F10) Utilities

Access the BIOS Setup Utility by pressing the F10 button during startup. Use Computer Setup (F10)
Utility to do the following:
●
Change factory default settings.
●
Set the system date and time.
●
Set, view, change, or verify the system configuration, including settings for processor, graphics,
memory, audio, storage, communications, and input devices.
●
View processor and memory settings
●
Modify the boot order of bootable devices such as hard drives, diskette drives, optical drives, or
USB media.
●
Run hard drive self-tests.
●
Establish a supervisor password that controls access to Computer Setup (F10) Utility and the
settings described in this section.

Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning the computer on or restarting the system. To access
the Computer Setup Utilities menu, complete the following steps:
1. Turn on or restart the computer.
2. As soon as the computer is turned on, press
to enter Computer Setup. Press
NOTE:
press
3. The Computer Setup Utility screen is divided into menu headings and actions.
Five menu headings appear on the Computer Setup Utility screen:
●
Main
●
Advanced
50 Chapter 5 Computer Setup (F10) Utility
If you do not press F10
F10 before the unit boots to the operating system to access the utility.
F10 before the system boots to the operating system
Enter to bypass the title screen, if necessary.
at the appropriate time, you must restart the computer and again