Table of Contents
Advertisement
might be necessary to set up one client to establish a BSS (Basic Service Set) and wait
briefly before setting up other clients. This prevents several clients from trying to establish a
BSS at the same time, which can result in multiple singular BSSs being established, rather
than a single BSS with multiple clients associated to it.
5. Check that the Network Connection for the wireless client is configured properly.
6. If Security is enabled, make sure that the correct encryption keys are entered on both the
Adapter and the access point.
Q. I can't find any wireless access point / wireless device in 'Site Survey' function.
A.
1. Click 'Rescan' for few more times and see if you can find any wireless access point or
wireless device.
2. Please move closer to any known wireless access point.
3. 'Ad hoc' function must be enabled for the wireless device you wish to establish a direct
wireless link.
4. Please adjust the position of network card (you may have to move your computer if you're
using a notebook computer) and click 'Rescan' button for few more times. If you can find the
wireless access point or wireless device you want to connect by doing this, try to move
closer to the place where the wireless access point or wireless device is located.
Q. Nothing happens when I click 'Launch config utilities'
A.
1. Please make sure the wireless network card is firmly inserted into your computer's PCI Card.
If the Planet configuration utility's icon is black, the network card is not detected by your
computer. Switch the computer off and insert the adapter again. If this doesn't work,
contact the dealer of purchase for help.
2. Reboot the computer and try again.
3. Remove the driver and re-install.
4. Contact the dealer of purchase for help.
Advertisement
Table of Contents
