Planet WNL-9331 User Manual page 45

Beacon (ms)
TX Power
Idle Time
No forwarding among wireless
clients
Hide SSID
Allow BW 40MHz
Default
Tx BURST
To save changes, click 'Apply button. Or you can click 'Default' to reset all values to factory
default value.
0: FCC (US, Canada, and other countries uses FCC radio
communication standards)
1: ETSI (Europe)
2: SPAIN
3: FRANCE
4: MKK
5: MKKI (TELEC)
6: ISERAL (Channel 3 to 9)
7: ISERAL (Channel 5 to 13)
The operating frequency channel will be restricted to the
country / region user located before importing
You can define the time interval that a beacon signal should be
send. Default value is 100. Do not modify this value unless you
know what will be affected
You can select the wireless output power here. Please select a
proper output power setting according to your actual needs.
You may not need 100% of output power if other wireless
clients are not far from you.
Select the idle time of your wireless network card. Default
value is 300. Do not modify this value unless you know what
will be affected
Check this box and wireless clients will not be able to share
data with each other.
Check this box and the SSID will not be broadcasted to the
public. Your wireless clients must know the exact SSID to be
able to connect to your computer.
This option is useful to enhance security level.
Check this box to allow BW 40MHz capability.
Click this button to restore all settings in this page back to
default value.
Check this box to accelerate the data transmit rate. It may not
work with all wireless access point and wireless devices.