Setting Up Tcp/Ip Address Controls - IBM Safenet/400 Reference Manual

Setting up TCP/IP Address Controls

SafeNet/400 allows you to specify which client IP addresses are either accepted or rejected by
the Telnet and the FTP Servers.
Turning on TCP/IP Address Checking
To set-up and turn on TCP/IP address checking for the FTP Server and Rexec Server
1. Type WRKTCPIPA *FTPSERVER then ENTER
2. Add the IP addresses to the Control Table
3. Type CHGFTPSET then press F4
4. Change Server Source limit by IP Address? to *YES then ENTER
5. Use WRKSRV command and set the *FTPSERVER and/or *REXEC Server exit
point to level 3 or 4.
To set-up and turn on TCP/IP address checking for the FTP Client:
1. Type WRKTCPIPA *FTPCLIENT then ENTER
2. Add the IP addresses to the Control Table
3. Type CHGFTPSET then press F4
4. Change Client Target limit by IP Address? to *YES then ENTER
5. Use WRKSRV command and set the *FTPCLIENT exit point to level 3 or 4.
To set-up and turn on TCP/IP address checking for TELNET:
1. Type WRKTCPIPA *TELNET then ENTER
2. Add the IP addresses to the Control Table
3. Type WRKSRV
4. Change the *TELNETON point to Level 3
3.6
SafeNet/400 Reference Guide
© Copyright 2008 MP Associates of Westchester, Inc.
V8.50 - May 2008