Chapter 5. Setting Up The Pci-X Dual Channel Ultra320 Scsi Raid Adapter (Aix); Verifying The Installation; Verifying Aix Software Installation; Verifying Hardware Installation - IBM Ultra320 Installation And Using Manual

Ibm pci-x dual channel scsi raid adapter installation and using guide
Hide thumbs Also See for Ultra320:
Table of Contents

Advertisement

Chapter 5. Setting Up the PCI-X Dual Channel Ultra320 SCSI
RAID Adapter (AIX)
This chapter provides AIX-specific hardware and software installation verification, adapter configuration,
and problem-determination procedures.
Note: If you are using Linux, see "Verifying the Installation" on page 16. If you have another operating
system installed, refer to your operating system documentation for information regarding configuring
your system.

Verifying the Installation

Verify the initial installation by using the following procedures:
v Verifying AIX Software Installation (lslpp)
v Verifying Hardware Installation (lsdev)

Verifying AIX Software Installation

To verify that the device driver software for the PCI-X Dual Channel Ultra320 SCSI RAID Adapter is
installed, do the following:
1. If necessary, log in as root user.
2. Type:
lslpp -l devices.pci.14107802*
Press Enter.
If the PCI-X Dual Channel Ultra320 SCSI RAID Adapter device driver software is installed, the following is
an example of the data that displays on your screen:
devices.pci.14107802.diag 5.2.0.11 COMMITTED PCI-X Dual Channel Ultra320 SCSI RAID Adapter Diagnostics
devices.pci.14107802.rte
devices.pci.14107802.ucode 5.2.0.0
Note: The fileset number 5.2.0.11 displayed in the example might be different from the output displayed
on your screen.
If no data displays on your screen, the PCI-X Dual Channel Ultra320 SCSI RAID Adapter device driver did
not install. Return to Chapter 3, "Installing the Device Driver Software (AIX)," on page 5. Then continue
with "Verifying Hardware Installation."
If you continue to experience problems, it may be necessary to call your system support organization.

Verifying Hardware Installation

To verify that your system unit recognizes the PCI-X Dual Channel Ultra320 SCSI RAID Adapter, do the
following:
1.
If necessary, log in as root user.
2. Type:
lsdev -Cs pci | grep sisioa
Press Enter.
If the PCI-X Dual Channel Ultra320 SCSI RAID Adapter did install correctly, the following is an
example of the data that displays on your screen:
sisioa0
Available 14-08 PCI-X Dual Channel U320 SCSI RAID Adapter
5.2.0.11 COMMITTED PCI-X Dual Channel Ultra320 SCSI RAID Adapter Software
COMMITTED PCI-X Dual Channel Ultra320 SCSI RAID Adapter Microcode
9

Advertisement

Table of Contents
loading

Table of Contents