Attaching The Return Hose; Attaching The Paint Hose; Attaching The Pail Bracket; Pressure Relief Procedure - WAGNER High-performance Airless Sprayer Owner's Manual

Attaching the Return Hose

1. Be sure that the motor switch is turned to OFF.
2. Screw the brass fitting found in the literature set into the return
tube port on the side of the pump and tighten firmly by hand.
NOTE: Do not overtighten. Hand-tighten only. Some
threads will be visible even when fully
tightend.
3. Press the return tube onto the brass fitting and secure
with the clamp provided.

Attaching the Paint Hose

1. Attach the high pressure hose to the paint hose port. Use
an wrench to tighten the paint hose securely.
2. Attach the gun to the other end of the high pressure hose.
Tighten securely with two wrenches.
3. Plug the sprayer into a properly grounded outlet or heavy
duty grounded extension cord. Do not use more than 100
feet of cord. If you must spray a long distance from a
power source, use more paint hose, not more extension
cords. Use a minimum size of 16 gauge for power
extension cords up to 50 feet in length, or 12 to 14 gauge
for power extension cords between 50 and 100 feet in
length.
R English

Attaching the pail bracket

1. Slide the pail bracket onto the pump housing and attach
with the self-tapping screws provided, one on each side of
the pump assembly.
NOTE: If you are setting the sprayer up for the first
time, wait to attach the pail bracket until after
you have primed the pump.
PRESSURE RELIEF
PROCEDURE
Follow this procedure after the unit is assembled and before
any operation which involves the spray gun such as cleaning
and maintenance or changing tips or accessories.
1. Turn the pressure control knob counterclockwise to its
lowest setting.
2. Turn the PRIME/SPRAY knob to PRIME (
Pressure Control Knob
3. Trigger the gun to remove any pressure which may still be
in the hose.
4. Lock the gun by turning the gun trigger lock so that it is
parallel to the gun body.
WARNING
Injection hazard. Do not spray without the tip guard in place.
NEVER trigger the gun unless the tip is completely turned to
either the spray or the unclog position. ALWAYS engage the gun
trigger lock before removing, replacing or cleaning tip.
6 © 1996 Wagner Spray Tech - All rights reserved.
).
PRIME/SPRAY Knob
Locked Off