Connecting The Remote Wake-Up Cable - IBM EtherLink XL User Manual

2-4 C
HAPTER

Connecting the Remote Wake-Up Cable

WARNING: Install the adapter in slot 1 in the PC (as
described earlier) before plugging in the 3-pin connector.
Only properly trained and authorized personnel should
perform service. Contact your PC manufacturer for
information about safe service techniques.
1 Insert the cable into the connector on the adapter,
shown in Figure 2-3.
Twist the cable twice before attaching the cable to the
motherboard.
2 Attach the cable to the connector on the PC
motherboard, as shown in Figure 2-3.
The connector is located in different locations depending
on the PC.
Figure 2-3 Connecting the Adapter to the Connector
3 Reconnect all cables and replace the PC cover.
The 3C905B-TX Remote Wake-Up adapter is installed. Go
back to the previous section, "Connecting to the Network,"
to complete installation.
2: I A
NSTALLING THE DAPTER
Power
supply
Connect Remote Wake-Up
cable from adapter to
motherboard connector
Plug in Remote Wake-Up
cable to connector here