User Responsibility; Transportation Methods; Packaged Items - Thermal Arc Fabricator 211i Operating Manual

FABRICATOR 211i

2.05 User Responsibility

This equipment will perform as per the information con-
tained herein when installed, operated, maintained and
repaired in accordance with the instructions provided.
This equipment must be checked periodically. Defective
equipment (including welding leads) should not be used.
Parts that are broken, missing, plainly worn, distorted or
contaminated, should be replaced immediately. Should
such repairs or replacements become necessary, it is
recommended that such repairs be carried out by ap-
propriately qualified persons approved by Thermal Arc.
Advice in this regard can be obtained by contacting an
Accredited Thermal Arc Distributor.
This equipment or any of its parts should not be altered
from standard specification without prior written ap-
proval of Thermal Arc. The user of this equipment shall
have the sole responsibility for any malfunction which
results from improper use or unauthorized modifica-
tion from standard specification, faulty maintenance,
damage or improper repair by anyone other than ap-
propriately qualified persons approved by Thermal Arc.

2.06 Transportation Methods

This unit is equipped with a handle for carrying pur-
poses.
!
ELECTRIC SHOCK can kill. DO NOT TOUCH
live electrical parts. Disconnect input power
conductors from de-energized supply line
before moving the welding power source.
!
FALLING EQUIPMENT can cause serious
personal injury and equipment damage.
Lift unit with handles built into the top of the front and
rear moulded panels.
Use handcart or similar device of adequate capacity.
If using a fork lift vehicle, place and secure unit on a
proper skid before transporting.
INTRODUCTION
WARNING
WARNING
2-2

2.07 Packaged Items

Fabricator 211i Power Source (Part No. W1004206)
• Fabricator 211i Inverter Power Source
• Shielding Gas hose assembly
• Operating Manual
Fabricator 211i System Part No. (W1004207)
• Fabricator 211i Inverter Power Source
• Feedrolls 0.6/0.8mm "V" groove (fitted),
0.9/1.2mm "V" groove,
1.0/1.2mm "U" groove,
0.8/0.9mm "V" knurled,
• MIG gun 3m long
• Electrode Holder with 4m lead
• Work Clamp with 4m lead
• Shielding Gas hose assembly
• Operating Manual
Figure 2-1: Fabricator 211i System Packaged W1004207
INTRODUCTION
Manual 0-5225