Type 8316 - IBM ThinkCentre 2296 Hardware Maintenance Manual

4. If the front bezel was removed, replace it by aligning and pressing the bezel

Type 8316

Drive bay information
Any bay that does not have a drive installed has a static shield and bay panel
installed.
The following illustration shows the locations of the drive bays.
The following table describes the drive height limitation for each drive bay.
Bay 1 and Bay 3 - Maximum height: 25.8 mm (1.0 in.)
Bay 2 - Maximum height: 43.0 mm (1.7 in.)
Removing a drive
1. Remove the cover. See "Removing the cover" on page 32.
2. Pivot the drive-bay latch handle toward the front of the computer and then
3. Disconnect the signal cable and power supply cable from the drive being
54
Hardware Maintenance Manual
into position. Continue at "Connecting the drive" on page 56.
pivot the drive-bay cages upward, as shown, until latched in the upright
position.
replaced.