Replacing A Microprocessor (All Machine Types) - IBM ThinkCentre 2296 Hardware Maintenance Manual

4. Lift the power supply out.
To replace the power supply, do the following:
1. Install the new power supply and insert the two screws that hold the power
2. Reconnect all power supply cables to the system board and the drives. See
3. Go to "Replacing the cover and connecting the cables" on page 64.

Replacing a microprocessor (all machine types)

To remove the microprocessor, do the following:
1. Turn off the computer and peripheral devices and disconnect all external cables
2. Remove any air baffles or ducts that cover the microprocessor.
3. Disconnect the heat sink fan cable from the system board. Refer to "Identifying
supply in place.
"Identifying parts on the system board (all machine types)" on page 40.
and power cords; then, remove the cover. See "Removing the cover" on page
32.
parts on the system board (all machine types)" on page 40.
Chapter 6. Replacing FRUs
61